考虑以下代码片段，
%% Declare figures
figure(1); % Plot Measured (y) Vs Reference(x) data for 6 cases
figure(2); % Plot Regression fit for Measured vs Reference for 6 cases
%% Run algorithm for 6 cases
for i=1:6
:
:
subplot(3,2,i);plot(x,y); % should go to figure 1
:
linearfittype = fittype({'0','x','1'});
f = fit(f,x,y);
subplot(3,2,i);plot(f,x,y); % should go to figure 2
end
如何将子图分配给适当的数字？
如果我理解正确，那么只要在声明之前figure(1)或figure(2)之前写就足够了subplot。
如果
h是现有图形的句柄或Number属性值，则figure(h)使该现有图形成为当前图形，使其可见，并将其移至屏幕上所有其他图形的顶部。当前图形是图形输出的目标。
所以：
%% Declare figures
figure(1); % Plot Measured (y) Vs Reference(x) data for 6 cases
figure(2); % Plot Regression fit for Measured vs Reference for 6 cases
%% Run algorithm for 6 cases
for i=1:6
:
:
figure(1) %// make figure 1 the current figure
subplot(3,2,i);plot(x,y); %// should go to figure 1
:
linearfittype = fittype({'0','x','1'});
f = fit(f,x,y);
figure(2) %// make figure 2 the current figure
subplot(3,2,i);plot(f,x,y); %// should go to figure 2
end
本文收集自互联网，转载请注明来源。
如有侵权，请联系[email protected] 删除。
我来说两句